carburized

On Earth, that†™ s a super-hard ceramic use to grind carburized steel.

365 tomorrows » 2007 » February : A New Free Flash Fiction SciFi Story Every Day 2007

So long before being forwarded to Tampa Town, the iron ore, molten in the great furnaces of Coldspring, and brought into contact with coal and silicium heated to a high temperature, was carburized and transformed into cast iron.

From the Earth to the Moon 2003

Tough steels with a carbon content of less than 0.25% can be enriched with carbon (carburized) on their surfaces so that they contain 0.75 to

7. Surface Hardening Frank Wenghfer 1990

In fact it is very difficult to distinguish between these two hardening agents when examining a carburized steel under the microscope.

The Working of Steel Annealing, Heat Treating and Hardening of Carbon and Alloy Steel 1916

Steel containing from 3 to 3.5 per cent of nickel is carburized between 1,650 and

The Working of Steel Annealing, Heat Treating and Hardening of Carbon and Alloy Steel 1916

-- The carbon - and nickel-steel gears are carburized separately owing to the difference in time necessary for their carburization.

The Working of Steel Annealing, Heat Treating and Hardening of Carbon and Alloy Steel 1916

A good mixture should be porous, so that the evolved gases, which should be generated at the proper temperature, may move freely around the steel objects being carburized; should be a good conductor of heat; should possess minimum shrinkage when used; and should be capable of being tamped down.

The Working of Steel Annealing, Heat Treating and Hardening of Carbon and Alloy Steel 1916

The carburization then goes on for several hours before the furnace is cooled below the effective carburizing range, securing an ideal diffusion of carbon between the case and the core of the steel being carburized.

The Working of Steel Annealing, Heat Treating and Hardening of Carbon and Alloy Steel 1916

The rivet stud shown in Fig. 37 is carburized while of its full diameter and then turned down to the size of the rivet end, thus cutting away the carburized surface.

The Working of Steel Annealing, Heat Treating and Hardening of Carbon and Alloy Steel 1916

The carburized sleeves are heated in an automatic furnace, which takes them cold at the back and feeds them through to the front, by which time they are at the correct temperature.

The Working of Steel Annealing, Heat Treating and Hardening of Carbon and Alloy Steel 1916