stripboard

I mounted 3.3v and 1.8v linear regulators on a bit of stripboard along with the LED and its series resistor, and hooked it into the 0v and +5v lines.

Snell-Pym » Bench PSU made from an old PC power supply 2009

So I made a test circuit with four LEDs and their series resistors on a large piece of stripboard, with unnecessarily long leads on everything and a few different orientations of components, in order to check whether shrinkage is an issue at the kinds of scales I plan to work at:

Snell-Pym » Circuits in Epoxy 2009

There's a very clear schematic, a PCB design and a stripboard layout.

New super-simple DIY synth plans 2005

This is the prototype (which I made on stripboard - also easy) working.

RepRap: Blog 2010

The circuit boards are hand-wired on stripboard or tripad except for the nixie driver which needed a PCB to make the connections to the valve base of the nixies.

Gadget Venue 2009

I will use standard stripboard rather than create a printed circuit and again mounting the detector will be the tricky thing.

VideoHelp.com Forum 2009

I will use standard stripboard rather than create a printed circuit and again mounting the detector will be the tricky thing.

VideoHelp.com Forum 2009

I will use standard stripboard rather than create a printed circuit and again mounting the detector will be the tricky thing.

VideoHelp.com Forum 2009

But the one thing above all else I wish they could improve is to have a drag-and-drop support of the stripboard.

VersionTracker: Mac OS X 2008

The first mbed microcontroller hardware packages an NXP LPC1768 Cortex-M3 processor-based MCU and support components in a practical 40-pin 0.1 "pitch DIP form-factor, ideal for experimenting on solderless breadboard, stripboard and through-hole PCBs.

All DN headlines 2009